Wire cutters are used for cutting wire, wire and cable with thick diameter. There are three types of iron handle, pipe handle and insulated handle, among which the wire cutters with insulated handle can be used for live occasions, and their working voltage is less than 1000V. Wire cutters can be divided into dedicated wire cutters and ordinary wire cutters.

The jaw, the tooth jaw, the jaw and the bolt and nut jaw of the wire breaking pliers are assembled on both sides of the front of the central axis of the pliers. There is a groove at the back of the central shaft along one side of the closed Central Line. The closed Central Line along the plane of the clamp body is provided with a wound pliers mouth and a skinned pliers mouth. The winding jaw by 2, 3 two Φ Φ hole. It can clamp Φ 1.5 ~ Φ 4 lines, the steel core wire bonding jumper clamp wire coiling. The scalping jaw is Φ 1, 2, 3 blade hole Φ Φ, constitute and milling groove, it can pick off Φ 0.5 ~ 4 Φ fine silk, the insulation of the wiring head skin. The safety handle sleeve is an insulating handle sleeve with anti-dropping ring on the handle of the pliers, which can effectively prevent the pliers from dropping in the work at high altitude.

Common wire cutters can be used to cut residual wires during the installation of electricians or as cutting tools in the field of weak current. Its head flat oblique, tip is very small is its characteristic, most suitable for cutting resin forming incision and precision instruments on the very thin line and vinyl resin line, cut circuit board components on the long lead. Not only that, sometimes also can be used as disassembly.