By oil, suit for long-term continuous operation, keep the temperature steady, no flash on tiny and thin products, and no corrosion. However, the heater may be damaged if you do not use the thermo oil correctly or change oil routinely. Recommend to choose oil-type mold temperature controller when your required temperature is 150℃ or above.

YBMD series are ideal for water: By water, heating up faster, cooling better, harmless to your mold and more economic than oil type for maintenance and cost. However, the water boiling point is low and the element of different water may occur corrosion or limescale to affect the heat exchange and products quality. Recommend to choose water-type mold temperature controller when your required temperature is 150℃ or below.

To improve efficiency :

Automatical controls of mold temperature to give perfect moldings with every shot.

Keep mold at correct temperature even when the machine is stopped thus eliminating start-up delays in the morning or during daytime stops.

As mold temperature is kept at its optimized temperature, the injection molding machine can run at its maximum speed to suit the job.

To improve quality :

Steady controlled temperature makes plastic molding accurate in size and consistent with quality.

Accurate mold temperature solves the problem of plastic flow patterns, reducing flow and weld lines, gloss appearance, record grooves effect, silver streaking, stress-whitening, warping, and etc....

Structure features :

Water/oil dual-purpose design can use either water or oil as heating media.

Special compact construction means both heating and cooling of the medium being used is done within the unit. (Exclude the model with a vertical pump)

PID temperature controllers are used for accurate control of temperature within±1℃.

Two-step-heating selector makes rapid temperature increasing possible when required thus saving time and power especially start-up in the morning.

The stainless steel tank guards against corrosion to ensure leak-free and long-lasting.6.Well thought of safety devices such as alarms for errors, circuit breakers, motor direction, overheat protector, auto-exhauster, and etc...