Crimping tongs are necessary for the conductor connection and crimping in the line construction and line repair in the power industry.

Wire clamp is a cold pressing method to connect copper and aluminum wires, especially in the construction of aluminum strand and steel-core aluminum strand. Pressure clamp can be roughly divided into two types of hand pressure and oil pressure. Conductor cross section of 35 m ㎡ and under pressure clamp with the hand, more than 35 m ㎡ with gear pressure pliers or hydraulic clamp.

Tin-coated aluminium wires are usually connected in the same way as copper wires. Non-galvanized aluminum wire is very simple oxidation, if the connection is not appropriate, the connection will be hot, and even affect the safety of the circuit. (1) selection of compression film and oval aluminum sleeve according to the wire section;

(2) strip the insulation sheath of the conductor at the connection. Strip the length of the aluminum sleeve, which is usually plus 5~10mm (naked aluminum wire does not have this kind), and brush the oxide layer (film) on the surface of the core wire with steel wire;

(3) with another clean wire brush dipped in some vaseline zinc paste evenly altered on the core wire, to prevent the regeneration of the oxide layer.

(4) use a round wire brush to remove the oxide layer and oil scale on the inner wall of the aluminum casing, and preferably apply vaseline zinc paste on the inner wall of the pipe.

(5) Pierce two core wires into the aluminum sleeve relatively, so that the two wire ends meet exactly in the middle of the aluminum sleeve.

(6) according to the thickness of the aluminum sleeve, select an appropriate wire mold and install it on the clamp. After tightening the positioning screw, insert the core wire with aluminum sleeve into the wire mold.

(7) align the aluminum sleeve, squeeze the clamp handle with force, and then press: first press the two pits at both ends, then press the two pits in the center, the pressure pit should be upward. After the end of the joint pressing, check the aluminum sleeve bending should not be greater than 2% of the pipe length, or it should be straightened with a wooden hammer; Aluminum sleeve should not have cracks; The wire outside the aluminum sleeve shall not have the appearance of "lantern" shape bulge or "cramp" shape irregularity.

(8) wipe off the remaining ointment and apply a layer of quick-drying bituminous paint at both ends and the joint of the aluminum sleeve. And then aluminum sleeve and exposed wire some first wrap two layers of yellow wax belt, then wrap two layers of black tape, always hold to the insulation layer 20mm local 2, aluminum core (single) strand wire and equipment bolt compression type wiring pile connection method (1) according to the core wire thickness choose appropriate aluminum lug.

(2) brush away the oxide layer on the surface of the core wire and evenly apply vaseline zinc powder.

(3) brush away the oxide layer on the inner wall of the lug jack, and coat the inner wall with vaseline zinc powder.

(4) insert the core wire into the connector hole of the lug and insert it to the bottom of the hole.

(5) select the appropriate wire mold and press two pits on the front of the lug. First press the outer pit and then the inner pit. The two pits should be on the same line.

(6) wrap the insulating tape between the wiring ear and the wire stripping insulating layer (the insulating tape shall be wrapped from the wire insulating layer).

(7) brush away the oxide layer on the opposite side of the lug and evenly apply vaseline zinc powder.

(8) make the opposite side of the lug downward and put it on the screw of the lug head, then successively put on the plain washer and tension washer and fix them tightly with the nut.